Storage Serviceability Standard

SB740-6720-91-001

Page

Paragraph

Section I

II STORAGE AND SPECIAL INSTRUCTIONS

Preservation, packaging, and packing

Marking

Storage

Disposition of rejected materiel

Appendix A REFERENCES

B FEDERAL STOCK NUMBERS AND TEST REQUIREMENTS

C PRESERVATION. PACKAGING. AND PACKING

D STORAGE QUALITY ASSURANCE PROVISIONS

SECTION I.

INTRODUCTION

1. Purpose.

(1) Storage serviceability standard. A writ-

ten procedure providing storage methods and

This bulletin provides a storage serviceability

standards and prescribing the necessary require-

standard which establishes uniform criteria for

ments for the surveillance of materiel in storage.

determining the acceptability of the items desig-

(2) Storage quality level (SQL). That quality

nated herein for continued storage and/or issue,

level applicable to storage sampling inspection

on the condition that all specifications and re-

expressed in terms of percent defective or de-

quirements applicable to the items have previ-

fects per 100 units, whichever is applicable, speci-

ously been met at the time of receipt from new

fied for a given group of defects of a product. I t

procurement. or after repair, overhaul, or rebuild

is the maximum allowable accidental departure

by a CONUS depot maintenance shop.

from specification requirements which can be tol-

erated.

2. Scope.

This bulletin applies to all activities engaged in

4. General. It is the Army's objective to attain

the receipt. storage, and issue of Camera Set.

and maintain a constant materiel readiness status

Still Picture KS-15(4) hereinafter referred to as

for materiel in depot stocks. The scope of such

the camera set listed in appendix B with the fed-

an objective is of such magnitude that only gen

eral stock number (FSN).

era1 guidelines are provided by chapter 3, section

VIII of TM 743-200-l for the quality evaluation

finitions. a Definitions for the majority of

of materiel in the custody of supply and storage

specialized terms used can be found in MIL-STD

activities. This standard supplements TM 743-

-109B.

200-1 by providing a systematic procedure for

b. Definitions for other specialized terms are

ic inspection of the camera set, speci-

as follows:

TACO 3520A