 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
  LUBRICANT·NTERVAL
I
INTERVAL· UBRICANT
L
Air Filter Drain
(See note 4.)
Air Filter
(Check element)
(See note 4.)
Drive Motor Fittings
(Sparingly)
Air Blower Pump
Shaft Bearings
P.I.V. Drive Gearbox
Level I Gage
Air Blower Lubricator
(Check level)
well
(See key)
(Keep filled)
P.I.V. Drive Gearbox
Blower Drive Motor
Drain Plug
(Sealed bearings
(Drain and refill)
no lubrication requi
red)
Tension Roller
P.I.V. Drive Gearbox
Bearing
Fill Plug
(See key)
Feed Roll Bearing
GAA
Motor
Generator
Bearings
(Sparingly)
(See note
3.)
NOTES:
4. AIR FILTER. Every 10 hours open drain cock on filter, if oil runs out
drain filter. Every 50 hours check filter element, if element shows signs of
oil saturation change element.
1. OIL CAN POINTS. Every 10 hours apply 1 or 2 drops of OE OIL every
time the press is used, oil can points are pointed red throughout the press.
Apply oil to all moving parts sparingly. Wipe off excess oil with a clean
Copy of this Lubrication Order will remain with the equipment at all times;
cloth.
instructions contained herein are mandatory.
2. LUBRICANTS. The following is a list of lubricants with the Military
BY ORDER OF THE SECRETARY OF THE ARMY:
Symbols and applicable specifications numbers.
W. C. WESTMORELAND,
OE MIL-L-2104
GAA MIL-G-10924
General, United States Army,
3. MOTOR GENERATOR. Every 500 hours remove plugs from ends of
Chief of Staff.
generator and install grease fittings and apply GAA grease sparingly.
OFFICIAL:
Remove fittings and reinstall plugs.
KENNETH G. WICKHAM
Major General, United States Army,
The Adjutant General.
LO 10-3610-200-12 DISTRIBUTION: To be distributed in accordance with DA Form 12-25, Section I, (qty rqr block No. 162) Organizational Maintenance
requirements for Printing and Reproduction.
LO10-3610-200-12
GPO 817-005
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals