Figure 3-9. Placement of disk.

TM 9-1370-202-12

CAUTION

between ignition fuze setting dial and lanyard disconnect

Do not permit tape to overlap

(fig. 3-9).

weather cap.

(j) Slide cardboard disk down lanyard until it

(m) Hold lanyard in place while securing it

rests on ignition fuze setting dial. Position disconnect in

with 2-inch tape (A and B, fig. 3-11). Assure that tape

fuze cavity on top of cardboard disk (A, fig. 3-10).

does not cover swivel loop. (This step requires two

(k) Carefully

remove

flare

from

arming

people.).

trough.

(n) Secure weather cap and swivel loop with

(l) Replace weather cap (B, fig. 3-10). Wind

tape (C, fig. 3-11). Fold over approximately one-half

lanyard around flare approximately 1'/2 inches down

inch of tape on free end to form pull tab. Take care to

from top of fuze (C, fig. 3-10). Lanyard will encircle

place pull tab on lanyard side of swivel loop.

flare case approximately 11/2 times.

Figure 3-9. Placement of disk.

3-11