Figure 2-9. Loading flare on dispenser assembly.

TM 9-1370-201-12

(3) Assure that safety pin is in place and that

(5) Using forefinger of right hand and thumb

ejection dial indicator is set on SAFE.

of left hand, set ejection dial indicator (fig. 2-3) by

turning clockwise to desired setting (table 2-1). A

(4) Visually inspect flare for damage.

spring-loaded detent holds the ejector dial indicator at

Contact authorized disposal personnel for disposal of

each setting and aids in setting fuze in darkness, since

damaged flares.

engagement of the detent can easily be felt.

(6) Remove loading gate of dispenser

WARNING

assembly by releasing latch and lifting gate off support

For launch from aircraft operating

pins.

below 70 knots indicated airspeed

(7) Load flare (fig.

2-9) into dispenser

(KIAS), a minimum fuze setting of

assembly by putting pull cable assembly in overhead

1,000 feet shall be used.

track and pushing flare along base tray until it is against

dispensing gate.

Figure 2-9. Loading flare on dispenser assembly.

2-10