Mk 45 Mod 0 With Adapter

TM 9-1370-201-12

Figure 2-8. Continuity test setup for flare dispenser XM19.

fingertight in order to remove all lateral backlash

(4) Assure that safety switch is in SAFE

movement of dispenser assembly, and secure screw

position with cover down.

with its locking nut.

(5) Assure that safety valve handle is in

SAFE position.

(8) Unfold snout so that it extends through

right-side opening and secure by locking strut and snout

2-4. Mk 45 Mod 0 With Adapter

tension latches. To properly secure latches, it may be

a. Preparation for Use.

necessary to again aline screws at bottom of struts.

NOTE

d. Preparation for Use. Prior to every mission,

Only flare Mk 45 Mod 0 with adapter

perform following inspections or tests.

can be launched from flare dispenser

XM19.

(1) Perform

electrical

continuity

test

(1) Remove tape from container, lift top half,

and remove flares.

(2) Assure that seal on nitrogen cylinder is

unbroken.

(2) Remove plastic cap from fuze end of

flare.

(3) Assure that bail is under firing device

handle.

2-9