Flare Dispenser XM19

TM 9-1370-201-12

2-3. Flare Dispenser XM19

(3) If flare has been hooked up for launch,

assure that lanyard swivel snaphook is disconnected

from safety clip key ring.

a. Installation of Jettison Assembly.

(4) Turn

ejection

dial

indicator

counterclockwise to SAFE position.

(1) Assure that nitrogen cylinder has not been

(5) Examine flare for damage.

Contact

fired inadvertently. Assure that seal is not broken and

authorized disposal personnel for disposal of damaged

valve pin is not protruding (fig. 17).

flares.

(6) Remove tape securing lanyard to case

NOTE

and uncoil lanyard.

If seal is broken and valve pin

(7) Remove tape securing lanyard to fuze.

protrudes, nitrogen cylinder must be

(8) Install lanyard retainer and recoil lanyard

replaced.

inside of fuze well; replace plastic cap.

(9) Remove or block out fuze setting marked

(2) Mount track plate on helicopter floor with

on outer case with grease pencil.

safety valve end facing right side of helicopter as

follows:

(10) Repack serviceable flares in containers.

Replace tape on containers. Use repacked flares first in

(a) Mate snap-on fittings to tiedown

subsequent launchings.

points indicated in figures 2-5 and 2-6.

Figure 2-5. Diagram showing mounting points for securing

truck plate to floor of helicopter models UH-1B and UH-1C.

2-6