Figure 6. Marking Control Line at 282 Inches.

TM 10-1670-327-23&P

0005 00

8. Once the measurements are completed, route both lower control lines (left and right) to the center of

both left and right suspension line groups, ensure the lower control lines are free and clear and to the

inside of the suspension line groups.

9. Pass each lower control line (figure 7, item 1) through the two control line channels (located on the

inside of each rear riser) (figure 7, item 2), then through the guide ring (figure 7, item 3) and finally

through the wooden toggle (figure 7, item 4).

Figure 7. Routing Control Line Through Channel, Guide Ring, and Toggle.

10. Push the toggle (figure 8, item 1) up past the 282-inch mark (figure 8, item 2) and tie two overhand

knots (figure 8, item 3) on top of each other, below the toggle, such that the yellow mark (282-inch

mark) is located in the center of the first knot.

0005 00-5