Pack Tray Assembly

TM 10-1670-327-23&P

0002 00

Pack Tray Assembly. The pack tray assembly (20 x 14 x 14 inches) (Figure 2) is constructed of duck

textured nylon fabric, and consists of the following:

Pack closing flaps (four) (figure 2, item 1): right and left side flaps, and upper and lower end flaps

with reinforced pack closing grommets (four) sewn into pack closing flaps.

Static line stow bars (inner and outer) (figure 2, item 2 and item 3).

Static line slack retainer loop with retainer (figure 2, item 4).

Waistband adjuster panel (figure 2, item 5).

Metal adjuster (figure 2, item 6).

Waistband (43 inches long) (figure 2, item 7).

Pack closing loop (figure 2, item 8) (Spectra® loop with nylon retaining tab used to align grommets in

pack closing flaps and is held in place by curved pack closing pin).

Two 5-1/2-inch lengths of Type VII Nylon webbing (figure 2, item 9) sewn into upper edge of pack

tray (each with tuck tab and easy open snap) for use with sizing channels on T-11R harness.

Horizontal back-strap retainer (two) with pull-dot snap assemblies (figure 2, item 10).

Horizontal back-strap keeper (figure 2, item 11).

0002 00-6