|
| |
Back
TEST CHAMBER ASSEMBLY, MODEL 452 OPERATION UNDER USUAL CONDITIONS - CONT | Up
TM-10-1670-305-23P Automatic Ripcord Release AR2 Model 451 NSN 1670-01-369-7914 Test Chanber Assembly AR2 Model 452 NSN 1670-01-370-0752 Manual | Next
ELECTRONIC TEST CHAMBER ASSEMBLY, MODEL 453 OPERATION UNDER USUAL CONDITIONS |
TM 10-1670-305-23&P
TEST CHAMBER ASSEMBLY, MODEL 452
0009 00
OPERATION UNDER USUAL CONDITIONS
DECALS AND INSTRUCTION PLATES
CONNECTIONS SCHEMATIC decal provides identification of electrical connections (for location,
refer to Page 2, WP 0007 00).
PREPARATION FOR MOVEMENT
If necessary, open altitude chamber lid and remove AR2.
Prepare AR2 for storage or shipment (refer to WP 0023 00).
Disconnect control assembly power cable from 110 VAC outlet. Coil power cable behind control
assembly.
WARNING
The test chamber and carrying case weighs 70 lbs. The test chamber weighs 50
lbs. Use two persons or lifting device when moving or lifting to prevent injury to
personnel.
Install test chamber in carrying case. Close and lock carrying case lid.
0009 00-13/14 Blank
Change 1
|
