Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: TEST CHAMBER ASSEMBLY, MODEL 452 OPERATION UNDER USUAL CONDITIONS - CONT
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

Back
TEST CHAMBER ASSEMBLY, MODEL 452   0009  00 OPERATION UNDER USUAL CONDITIONS
Up
TM-10-1670-305-23P Automatic Ripcord Release AR2 Model 451 NSN 1670-01-369-7914 Test Chanber Assembly AR2 Model 452 NSN 1670-01-370-0752 Manual
Next
TEST CHAMBER ASSEMBLY, MODEL 452 OPERATION UNDER USUAL CONDITIONS - CONT

TM 10-1670-305-23&P TEST CHAMBER ASSEMBLY, MODEL 452   0009  00 OPERATION UNDER USUAL CONDITIONS - CONT OPERATING PROCEDURE NOTE Operating procedure for the Model 452 test chamber Assembly consists of evaluation testing of the AR2. 1.    Verify that the AR2 JUMP/OFF switch is in OFF position, the storage cable and piston rod cap are removed, refer to WP 0008 00, and that AR2 is cocked. WARNING If there is any indication of a leak in the aneroid, remove the AR2 from service.  A leaking aneroid may cause a malfunction which may result in death of parachutist. 2.    Check the AR2 for aneroid leakage at ground level before testing (WP 0008). NOTE Ensure that the AR2 is cocked and the piston rod cap is removed before performing test procedure. 3.    Set AR2 attitude dial to 5,500 feet. 4.    Install AR2 in the test chamber (Refer to initial adjustments before use). CAUTION To avoid damage to test chamber do not switch it on while the air compressor or vacuum pump is under load (while the altitude chamber is under vacuum or the air cylinder is pressurized).  If it has recently been used, wait one to two minutes for pressure trapped in the system to bleed off. 5.    Switch ON the test chamber.  The indicator light (6) will illuminate, and the air compressor and vacuum pump will start.  When switching the test chamber ON, immediately look under the transparent altitude chamber at the ends of both the air compressor and vacuum pump to ensure that the cooling fans are spinning on both units.  If either of the fans is not spinning, immediately cycle the CLIMB/FALL/COCK switch (8) between Fall and Cock until the fans spin. WARNING Do not move climb/fall/cock switch on test chamber to cock unless AR2 JUMP/OFF switch is in the fully off position.  Attempting to cock the mechanism with the switch in an intermediate position may damage internal components and render the AR2 inoperative.  This will prevent deployment of a parachute and may result in death of parachutist. Change 1 0009 00-6

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing