|
| |
Back
Tablet 2-2. Channel Selection/Frequency Cross Reference cont. | Up
TM-10-1670-302-10 Aerial Resupply and Accompanying Bundle System (ARABS) NSN 1670-01-351-8587 Manual | Next
Figure 2-11 T/C and Timer Programming (Sheet 2 of 3) |
2-6. Initial Programming. Checks, and Self Tests. Continued
a.
TIC programming - Continued
(5)
Select the AGU identity code by pressing AGU ID switches AGU 1
through AGU 6 (9), as applicable. Any number of these switches
may be selected, depending on the number of AGUs you intend to
operate with the same TIC and on the same frequency. If all six
AGU codes are to be used, they can be selected by pressing the
ALL switch (10) or by pressing all six of them one at a time. Those
AGUs which have been selected will blink. If the LED does not blink,
press the appropriate switch until the LED blinks. If the LED is red,
press the A (Auto) switch (11), then press the appropriate AGU
switch until a blinking LED is observed for all AGUs you desired to
operate with this TIC. The green blinking LED will allow the TIC to
transmit the auto homing code when it is turned on.
(6)
Press the AUX 5 (FREQ HOP) switch (12) if you wish to program In
the frequency hop mode. Frequency hopping will only work with
those AGUs that have all had their frequency hop switches turned
on. Frequency Hopping mode can only be used with channels 1-10.
2-36
|
