MC1-1C/MC1-1D TROOP BACK PARACHUTE ASSEMBLY ASSEMBLING THE MC1-1C/MC1-1D TROOP BACK PARACHUTE ASSEMBLY

TM 10-1670-292-23&P 0004 00 MC1-1C/MC1-1D TROOP BACK PARACHUTE ASSEMBLY ASSEMBLING THE MC1-1C/MC1-1D TROOP BACK PARACHUTE ASSEMBLY 0004 00-1 THIS TASK COVERS: � = Assembly INITIAL SETUP: Materials/Parts Tape, Adhesive, Pressure Sensitive, Blue (Item 37, WP 0055 00) Personnel Required 92R (10) Parachute Rigger Equipment Condition Parachute canopy in proper layout on packing table or other suitable surface. ASSEMBLY Assembling the MC1-1C/MC1-1D Parachute. When the parachute is received from the supply activity, and before it is packed for use, the components must be assembled. This must be accomplished during the layout of the parachute (WP 0011 00). If, in assembling components, any component is found to be defective, the parachute must be processed for repair. Place the components on a packing table and obtain proper layout of the canopy assembly; then assemble components as follows: 1. MC1-1C/MC1-1D Harness. Attach the harness to the pack tray as follows: a. Place the pack tray on the table, with back strap retainers and keepers up, and with the end flap containing the static line slack retainer toward the apex end of the table. b. Attach the harness to the pack tray as illustrated in the figure below, by threading each of the pack tray diagonal back-strap-retainers through the harness diagonal back-strap-channels (for the required size), and under the back-strap keepers.