ATTACHMENT OF CANOPY TO RISERS CONT.

TM 10-1670-287-23&P 0005 00 0005 00-8 j. Grasp the base line of the control line at the attaching loop again and using thumb and forefinger, trace the base line down to the 3^rd finger trap ensuring there are no full twists. k. Trace each cascade line attached to the base line ensuring there are no full twists and that each line is attached to the appropriate corresponding attaching loop. l. Starting with line 1C, trace the line to the bar tack using the thumb and forefinger and remove all twists. From the bar tack trace line 1D to the canopy-attaching loop then continue tracing line 1C from the bar tack to the canopy-attaching loop. m. Using the procedures from step l., above, trace lines 2C and 2D through 8C and 8D. n. Starting with line 1A, trace the line up to the bar tack using thumb and forefinger and remove all twist. Trace line 1B from the bar tack to the canopy-attaching loop, and then continue tracing line 1A to the canopy-attaching loop. o. Using the procedures in step n., above, trace lines 2A and 2B, 3A and 3B, 6A and 6B, 8A and 8B. p. Lines 4A and 5A are continuous. Trace each line from the connector link to the canopy attaching loops ensuring there are no twists and that line 4A and 5A are attached to the nose of the canopy. 5. Using ⁷/₁₆-inch open-end wrench, tighten barrel nut on connector links ¼ turn past hand tight. Base Line Cascade Lines Bar Tack