EXTRACTION LINE PANEL MARKING AND RESTENCILING EXTRACTION LINE PANEL

TM 10-1670-286-20 EXTRACTION LINE PANEL 0004 00 MARKING AND RESTENCILING EXTRACTION LINE PANEL 0004 00-1/(2 Blank) THIS SECTION COVERS: Marking, Restenciling. INITIAL SETUP Materials Personnel Required Brush, Stenciling-Item 3, Appendix C 92R (10) Parachute Rigger Ink, Marking-Item 7, Appendix C Marker, Felt Tip, Black-Item 8, Appendix C Equipment Condition Pen, Ballpoint-Item 10, Appendix C Stencil Board Oiled-Item 12, Appendix C Layout on packing table or other suitable area. MARKING NOTE Stenciling should be used whenever possible. A ballpoint pen or felt tip marker should be used only where stenciling is not possible, or when stenciling devices are not available. Any type ballpoint pen using black or blue ink may be used for marking on labels only. Original stenciling data or marking that becomes faded, illegible, obliterated, or are removed as a result of performing a repair procedure will be remarked with a ballpoint pen, felt tip marker, or restenciled. All marking or restenciling will be done on or as near as possible to the original location and should conform to the original lettering type and size. Using marking devices such as ballpoint pen or felt tip marker, mark on or as near as possible to original location and conform to original lettering type and size. RESTENCILING. 1. Cut oiled stencil board to original lettering type and size of data to be restenciled. 2. Place cut stencil board over or near as possible to original marking to be restenciled. 3. Place additional sheet of stencil board beneath the area to be stenciled to prevent the marking ink from penetrating to other areas. 4. Hold stencil board in place and using stenciling brush filled with parachute marking ink restencil original marking. END OF WORK PACKAGE