|
| |
Back
Figure 2-37. Breakaway Static Line Clevis Taped and Attaching Cord Installed | Up
TM-10-1670-282-23P Parachute Cargo Type: 34-Foot Diameter Model G-14 Low-Velocity Cargo Parachute NSN 1670-00-999-2608 Manual | Next
Section VI. REPAIR |
ARMY TM 10-1670-282-23&P
AIR FORCE T.O. 13C5-30-2
NAVY NAVAIR 13-1-33
Figure 2-38. Attaching Cord Connecting to Riser.
(5)
When a G-14 cargo parachute is to be used with a breakaway static line which will be connected to an anchor
line cable, the following shall be accomplished:
(a)
Remove the riser clevis from the static line end, reinstall the clevis pin and safety pin in the clevis, and
position the clevis above the static line end with the clevis pin facing the static line clevis attaching loop.
(b)
Cut a 12-inch length of nylon cord and remove the core threads. Center the cord length around the
clevis pin of the riser clevis removed in (a) above. Insure the cord ends are alined.
(c)
Pass each cord end through the static line clevis attaching loop from opposite directions and form a 4-
inch long loop between the clevis pin and the static line end (figure 2-38). Secure the cord running ends
on top of the static line clevis attaching loop with a surgeon’s knot and a locking knot. Make an
overhand knot in each running end. Trim each tie end at a point 2 inches from the locking knot.
2-51
|
