|
| |
Back
Packing the G-14 34-Foot Cargo Parachute | Up
TM-10-1670-282-23P Parachute Cargo Type: 34-Foot Diameter Model G-14 Low-Velocity Cargo Parachute NSN 1670-00-999-2608 Manual | Next
Figure 2-8. Rigger’s Orientation |
ARMY TM 10-1670-282-23&P
AIR FORCE T.O. 13C5-30-2
NAVY NAVAIR 13-1-33
2-16.
Packing the G-14 34-Foot Cargo Parachute (cont).
b.
Orientation. Throughout this manual, all directions (right, left, upper, lower, top, bottom, clockwise, and
counterclockwise) are given from the rigger’s point of view, as the rigger stands at the tension plate end of the packing table
facing the apex hook end of the table (figure 2-8).
(1)
Top, that portion of the equipment that is farthest from the packing surface.
2)
Bottom, that portion of the equipment that is nearest to the packing surface.
c.
Preparing Parachute for Proper Layout. Place packing tools in convenient locations on the packing table. Lay
the canopy assembly lengthwise on the packing table, attach the bridal loop to the packing table apex hook (figure 2-9) and
elongate canopy.
NOTE
When inversion, turns, tangles and twist are present in the canopy assembly, the proper sequence for
removal to achieve proper layout is to remove an inversion first, remove turns secondly, then remove
tangles and, finally, remove twist.
d.
Removing Inversions.
(1)
Canopy inversion. Check canopy vent lines to determine if canopy has been Inverted. Canopy Is Inverted when
vent lines are located inside upper lateral band. Remove inversion as follows:
(a)
Detach bridal loop from apex fitting and pass vent through canopy.
(b)
Pass vent out of canopy skirt, between two adjacent suspension lines (figure 2-10).
2-24
|
