|
| |
Back
Figure 2-14. Risers, Connector Links and Suspension Clevis in Proper Layout. | Up
TM-10-1670-281-23P Parachute Cargo Type: 64-Foot Diameter Model G-12D NSN 1670-00-893-2371 and Model G-12E NSN 1670-01-060-3705 Manual | Next
Figure 2-16. Canopy Vent Ties Completed |
ARMY TM 10-1670-281-23&P
AIR FORCE T.O. 13C5-32-2
NAVY NAVAIR 13-1-32
d. Packing the G-12D Parachute.
(1) Serving the canopy vent
(a) Remove the canopy bridle loop from the stationary post, insuring the dressed vent
reinforcement (upper lateral band) is not disturbed unnecessarily, and slide the bridle loop to
one side of the canopy vent lines.
(b) Cut a 10-inch square piece of type 11 cotton muslin cloth and wrap the cloth around the
center of the vent lines.
(c) Center the canopy bridle loop on the wrapped portion of the vent lines.
(d) Bring the cloth wrap ends together to form a loop around the bridle loop. Secure the cloth
wrap ends together with a 24-inch length of 1/4-inch wide, type I cotton webbing. Make the
tie with two turns single and secure the tie with a surgeon's knot and a locking knot. Trim tie
ends to 2 inches (figure 2-15).
(e) At a point 2 inches above that part of the bridle loop through which the vent lines pass, make
a tie around the bridle loop using a 24-inch length of 1/4-inch wide, type I cotton webbing
(figure 2-16). Make the tie with two turns single and secure the tie with a surgeon’s knot and
locking knot. Trim tie ends to 2 inches. Reconnect the bridle loop to the stationary post.
4839-024
Figure 2-15. Canopy Vent Lines Wrapped and Secured.
2-31
|
