Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: PARACHUTE ASSEMBLY IMMERSED IN SALT-WATER
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

Back
DRYING FABRIC ITEMS
Up
TM-10-1670-280-23P Parachute Cargo Type: 100-Foot Diameter Model G-11B G-11C and G-11D NSN 1670-01-016-7841 Manual
Next
PARACHUTE ASSEMBLY IMMERSED IN FRESH-WATER

TM 10-1670-280-23&P                                                       0008 00 0008 00-3 NOTE Equipment made of cotton fabric immersed in salt-water is to be condemned.  Refer to WP 0009 00, INSPECTION, for equipment disposition. PARACHUTE ASSEMBLY IMMERSED IN SALT-WATER If the parachute, or any of its components, has been immersed in salt-water in excess of 24-hours it will be condemned.  Additionally, if the parachute, or any of its components, has been immersed in salt-water for a period less than 24-hours, but cannot be rinsed within 48-hours after recovery, it will also be condemned.   However, if the cited time limitations can be met, then immediately upon recovery, suspend or elevate the parachute assembly in a shaded area and allow it to drain for at least 5-minutes.  Do not attempt to wring the fabric or the suspension lines.  Within 48-hours after recovery, under the supervision of a qualified parachute rigger (92R), rinse the recovered parachute assembly as follows: 1.    Place the parachute assembly in a large watertight container filled with a suitable amount of fresh, clean water to cover the assembly.    NOTE If salt water-soaked assembly is too large to be placed in a rinsing container, then the rinsing process will be affected by applying fresh, clean water using a hose. 2.    Agitate container contents by hand for 5-minutes. 3.    Remove parachute assembly from container and suspend or elevate it in a shaded area, allowing a 5- minute drainage period.  Do not attempt to wring the fabric or the suspension lines. 4.    Repeat procedures 1. through 3., above, twice, using fresh, clean water for each rinse. 5.    After third rinse, allow the parachute assembly to drain thoroughly.  Upon completion of draining, dry the assembly in accordance with the DRYING FABRIC ITEMS procedures detailed above. 6.    When dried, perform a technical/rigger-type inspection of the parachute assembly.  Corroded metal components, or corrosion-stained fabrics or suspension lines will be either repaired or replaced as prescribed by the MAC, WP 0050 00. 7.    Record any repairs, immersion and rinsing in the parachute log record as detailed in WP 0003 00, SERVICE UPON RECEIPT.

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing