Assembly of Minor Components

TM 10-1670-268-20&P 0004 00 0004 00-19 (13) Using the holes in the left and right side rail identified as 1-30, counting from the platform forward end, install the side rail bushings (1), ½-inch x 3⁷/₃₂-inch side rail bolts (2), and ½- inch flat washers (3), on each side of the platform. The bushings fit between the side rails and panel end members with the flat portion against the lip of the side rail and end member. The bushings are positioned by inserting them at each end of the rail and sliding them to each hole location. Pull outward slightly on the side rail to facilitate positioning of the bushings. Bolts should be left finger tight until all bushings, bolts and washers are in place. d. Assembly of Minor Components. (1) Installation of the Outrigger Link Assembly. Two personnel are required for this task. Install an Outrigger Link Assembly on each side of the aft end of the platform as follows: (a) Remove (pry out) the two black plastic hole plugs in the rear most panel, closest to the panel joint line, and the two black hole plugs in the adjacent panel, closest to the panel joint line. Push out, through these holes, the four black plastic plugs on the opposite surface. Save these plugs for use in remaining panels as required. FIRST MAIN PANEL IN SERIES OUTBOARD ROLLER PAD 1 2 SIDE RAIL 3 SECOND MAIN PANEL IN SERIES PLATFORM PANEL WELDMENT MOUNTING HOLE