ROLLER PAD INSTALLATION SEQUENCE CONT.

TM 10-1670-268-20&P 0004 00 0004 00-14 CAUTION The platform weighs approximately 89-pounds per foot of length. To avoid injury to personnel or damage to surrounding equipment, use extreme caution when lifting and handling. Never walk near or crawl beneath the assembled raised platform. Be careful not to damage the side rail notches when turning-the platform over. Short pieces of plywood should be used to prevent the edges of the rail from contacting a concrete floor or other hard surface. c. The steps required for the assembly of the major components of the dual row airdrop platform are as follows: (1) Construct a flat structure of sufficient mass and strength to support the weight of the platform at a safe, convenient work height. Ensure that the surface design allows for the clearance of the tie down rings. Ensure that the structure is a minimum 18-feet long and 72 to 75-inches wide. This size allows each panel surface to lay flat and helps to keep the assembled platform flat. NOTE The dual row airdrop platform must be assembled upside down. Roller pad bolts are installed through the roller pad and side rails into the bottom of the panels. Riveted-nut plate bars are located inside the panels. Approximately 24-Inch Working Height