ROLLER PAD INSTALLATION SEQUENCE CONT.

TM 10-1670-268-20&P 0004 00 0004 00-12 b. Cargo extraction system. The extraction bracket assembly and the outside and inside EFTA brackets must be installed on the platform. The following minor components must be installed on the platform, as illustrated below: NOTE The extraction bracket assembly must be installed so that the moveable lug will fold upward when the platform is right side up. The upper part of the extraction bracket is stenciled TOP. (1) Extraction bracket assembly. Attach an extraction bracket assembly (1) on the center of the rear panel, using a punch to align the four bolt-holes. Using a ¹⁵/₁₆-inch wrench, install the four ⁵/₈-inch x 3 ⁵⁷/₆₄-inch hex head bolts (2) with four ⁵/₈-inch flat washers (3) and the four ⁵/₈-inch nuts (4) also with four ⁵/₈-inch flat washers. These bolts must be installed from the bottom. NOTE See the appropriate Field Manual (FM) that applies to the load being dropped to determine the exact location on the side rail to attach the EFTA brackets. See the appropriate FM for attaching the EFTA to the brackets.