|
| |
Back
TYPE V AND DUAL ROW AIRDROP PLATFORM ASSEMBLING THE TYPE V AND DUAL ROW AIRDROP PLATFORM CONT. | Up
TM-10-1670-268-20P The Type V Airdrop Platform and Dual Airdrop Platform Manual | Next
ROLLER PAD INSTALLATION SEQUENCE CONT. |
TM 10-1670-268-20&P 0004 00
0004 00-8
ROLLER PAD INSTALLATION SEQUENCE
NOTE
Before installing side rail bushing, insure that the suspension
bracket assembly (if applicable) is positioned at the proper side rail
holes.
(13) Install side rail bushing (1) and ½-inch x 3 7/32-inch side rail bolts (2) with ½-inch flat
washers (3) for all the holes in the side rail. The bushings fit between the side rails and
panel end members with the flat portion against the lip of the side rail and the end member.
The bushing can be positioned by inserting them at the end of each side rail and sliding
them to each hole location, pulling upward slightly on the side rail to make positioning of
the bushing easier. Bolts should be left finger tight until all bushings and bolts are in place.
2
3
1
SIDE RAIL
BOLT INSTALLATION
SEQUENCE
1ST – ALL INBOARD ROLLER
PAD BOLTS
2ND – BOLTS ON INSIDE OF
OUTBOARD ROLLER PAD
3RD – BOLTS ON OUTER SIDE
OF OUTBOARD ROLLER
PAD
3
1
2
|
