Click here to make tpub.com your Home Page

Page Title: PERFORMANCE TEST PROCEDURES
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Back
Table 4-2. Analyzer Front Panel Checks
Up
TM-11-6625-2781-14-P-2
Next
PERFORMANCE TESTS

TM 11-6625-2781-14&P-2
Section IV
PERFORMANCE TEST PROCEDURES
4-22. PERFORMANCE TEST PROCEDURES
4-23. Input Impedance
SPECIFICATION:
Input Impedance: 50-ohm nominal. Reflection Coefficient.13 (1.3 SWR) for input attenuator settings0dB.
0
1
DESCRIPTION:
The RF input impedance is checked in two steps over the frequency range of 2 kHz to 110 MHz. A vector impedance
meter is used to check the 500 kHz to 110 MHz range. Over the 2 kHz to 500 kHz range, an oscillator is terminated in a
known impedance and calibrated. The voltage across the know impedance is then compared with the voltage across the
analyzer input.
Figure 4-3. Input Impedance Accuracy Test: 500 kHz to 110 MHz
EQUIPMENT:
RF Impedance Meter ................................ ................................ ................................ .......................... HP 4815A
Test Oscillator ................................ ................................ ................................ ................................ ...... HP 651B
AC Voltmeter ................................ ................................ ................................ ................................ ........ HP 400E
50-ohm Termination ................................ ................................ ................................ ......................... HP 11593A
BNC Cable Assembly (2) ................................ ................................ ................................ .................. HP 10503A
BNC Tee ................................ ................................ ................................ ................................ ............. UG-274B/
1
Connect equipment as shown in Figure 4-3 and make the following control settings:
ANALYZER:
RANGE MHz ................................ ................................ ................................ ................................ ............... 0-11
FREQUENCY ................................ ................................ ................................ ................................ ......... 30 MHz
4-6

Privacy Statement - Press Release - Copyright Information. - Contact Us