INSTALLATION CHECKOUT

TM 11-6625-2781-14&P-2

Section II

g. After the RF and IF sections are joined

b. Firmly grasp the middle part of latch flange and

pull RF/IF sections straight out.

mechanically and electrically, the complete assembly

is ready to insert in the display section mainframe.

c. Locate black press-to-release lever near left

front side of RF section.

Press this lever and

h. Pick up the RF/IF sections and center in

simultaneously exert an upward pulling force on front

opening of display section. Push forward until assembly

edge of RF section.

fits snugly into display section mainframe.

d. When the two sections separate at the front,

i. Push in front panel latch to securely fasten

raise RF section two or three inches and slide metal tab

assembly in place.

at rear of IF section out of the slot with which it is

engaged.

2-19. To separate the RF/IF sections from display

section and then to separate the RF section from the IF

section, proceed as follows:

2-20. INSTALLATION CHECKOUT

2-21. After equipping the display mainframe with the

a. Push front panel latch in direction of arrow until

plug-in RF/IF sections (Paragraph 2-17), the operation

it releases.

procedures specified in Section III should be performed.

2-2