TM 9-4120-411-14
4.37 TEMPERATURE SENSOR (RT1) REPLACEMENT - CONTINUED.
(2) Loosen four captive screws (1) then separate remote box (2) halves and lay it open being careful not to
damage wire leads.
(3) Cut and remove tiedown strap (3) securing temperature sensor (4) leads. Discard tiedown straps.
(4) Tag and cut temperature sensor (4) leads at solder connections. Remove and discard insulation sleeving
(5) pieces from wire lead ends.
(5) Remove two screws (6), lock washers (7), flat washers (8), and cover (9). Discard lock washers.
(6) Pull temperature sensor (4) leads through hole in remote box (2) to remove.
Figure 4-36. Temperature Sensor (RT1).
(1) Carefully push temperature sensor (4) leads through hole in remote box (2).
(2) Slide one piece of insulation sleeving (5) over each temperature sensor (4) lead. Connect leads using tags
each connection and heat to shrink in place using heat gun. Remove tags.
(3) Lay temperature sensor (4) over and place cover (9) over it. Align cover mounting holes and secure using
two flat washers (8), new lock washers (7) and screws (6).
4-92