TM 9-4120-411-14
4.33 ELECTRICAL ASSEMBLY MOUNTING BRACKET AND SLIDE REPAIR OR REPLACEMENT - CONTINUED.
NOTE
The slides are mounted to the bracket using a mixture of pan head and
countersunk screws. Note the location of these different screw types for proper
assembly.
(2) Remove 10 nuts (23), lock washers (24), three pan head screws (25), two countersunk screws (26), and
bracket (14).
(3) Remove 12 nuts (27), lock washers (28), screws (29), and two slides (30) from mounting bracket (18).
(1) Install two slides (30) onto mounting bracket (18) and align mounting holes. Secure with 12 screws (29),
lock washers (28), and nuts (27).
(2) Install bracket (14) and align mounting holes. Locate mounting hardware as noted during disassembly then
secure with three pan head screws (25), two countersunk screws (26), 10 lock washers (24), and nuts (23).
(3) Install handle (22), and secure using two flat washers (21), lock washers (20), and nuts (19).
(1) Install mounting bracket (18) assembly and align mounting holes. Secure using 11 flat washers (17), new
lock washers (16), and screws (15).
(2) Support electrical assembly (2) then turn to release three latches (3) and open power box assembly cover
(4). Pull bracket (14) out from unit then carefully place electrical assembly on bracket and align mounting
holes. Install eight flat washers (13), screws (12), flat washers (11), new lock washers (10), and nuts (9) to
secure electrical assembly to bracket.
(3) Connect power box assembly ground strap (8) to frame with flat washer (7), new lock washer (6), and nut
(5).
(4) Close power box assembly cover (4) and turn three latches (3) to secure.
(5) Carefully slide electrical assembly (2) into frame. Be sure no cables or wires are pinched. Secure with
eight captive screws (1).
(7) Connect FDECU main power cable to power source and operate per paragraph 2.4.
4-84