TM 9-4120-411-14
Section III. OPERATOR MAINTENANCE PROCEDURES
NOTE
The following maintenance procedure is the only one authorized to the operator
with the exception of any service and inspection procedures noted in Operator
3.1 CLEANING.
THIS TASK COVERS:
Cleaning
Initial Setup:
Materials/Parts
Detergent
Wiping Rag
WARNING
Rotating parts and lethal voltage levels are used in operating the FDECU. Be sure
power source is disconnected. Injury or death can occur if connected to power
source.
a. Shutdown the FDECU per paragraph 2.4 and disconnect it from power source.
WARNING
The FDECU cover is heavy. Be sure the cover retaining rod is in place and
properly secured with hair pin cotter. Injury can occur if cover drops.
b. Raise and secure cover if necessary to access inside of unit for cleaning.
c. Mix a small quantity of detergent with clean water to make a wash solution.
d. Dampen a rag with wash solution and clean the equipment.
e. Dampen a rag with clean water and rinse the equipment. Rinse rag in clean water and continue until all detergent
residue has been removed.
f. Wipe the equipment with a clean dry rag until thoroughly dry.
g. Lower and secure cover if raised for cleaning.
3-3/(3-4 blank)