TM 9-2330-211-14&P
4-12. COMPOSITE LIGHT ASSEMBLIES (Con't)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL OF COMPOSITE LIGHT ASSEMBLY
NOTE
If wire identification tags are missing or are not readable, wires
should be tagged to aid in installation.
Four electrical
9.
Composite light
Separate.
assembly (14) to
connectors (11)
wiring harness (12).
10.
Two screws (10) and
Composite light
Using socket and handle, unscrew and take out.
assembly (14) to
semitrailer
11.
Composite light
Carefully feed connector halves (11) through hole
assembly (14)
(13) in bracket and take off of semitrailer.
lNSTALLATION OF COMPOSITE LIGHT ASSEMBLY
12.
Composite light
a. Feed connector halves (11) through hole (13).
assembly (14)
b. Place into position and aline with screw holes
(8).
13.
Two screws (10) and
Screw into back of light assembly (14) and tighten
using socket and handle.
14.
Back of light
Four connector
Match and connect to four wiring harness
assembly (14)
halves (11)
connector halves (11) with the same wire numbers.
FOLLOW-ON MAINTENANCE:
Check operation of lights.
TASK ENDS HERE
4-13. CLEARANCE LIGHT ASSEMBLIES
This Task Covers:
a. Lamp and Lens Replacement
c.
Installation of Clearance Light Body
b. Removal of Clearance Light Body
Initial Setup:
Tools/Test Equipment:
Materials/Parts:
Screwdriver, cross-tip
Screwdriver, flat-tip
Wrench, open-end, in.
4-23