TM 9-2320-360-10
2-19. WINCH OPERATION (CONT)
(24) Set WINCH SPEED CONTROL (15) to LOW position.
(25) Push CABLE HOLD DOWN lever (16) to ON position.
(26) Push ENGINE SPEED CONTROL switch (17) to HIGH ENGINE IDLE position.
(27) Push ad release ENGINE SPEED CONTROL switch (17) forward to increase engine
speed.
WARNING
Personnel must exercise care when winding main winch cable onto
the drum. Winch drum should be checked frequently for proper
cable layering. Failure to comply may cause improper layering or
tangling of cable, resulting in injury to personnel.
CAUTION
Check cable routing before paying in cable. Failure to have
cable routed correctly may damage equipment.
If excess cable is laying on the platform or ground, assistant
must provide tension while the operator takes up the slack.
Failure to comply may result in damage to equipment.
NOTE
When both winch cables are being used, pay in cables in equal
amounts.
(28) Push down WINCH control (18) to CABLE IN position. Slowly tighten winch cable (4) to
recover disabled vehicle.
2-166 Change 1