TM 5-2420-230-10
c. Headlight Installation.
NOTE
Procedure to install headlights is the same for all locations. Right-side bucket position shown.
(1)
Position headlight assembly (7) on light mount (6).
(2)
Rotate T-bar (5) approximately 90 degrees, so that it will not fit between retaining bars on light mount (6).
(3)
Tighten knob (4) to secure T-bar (5) against retaining bars on light mount (6).
NOTE
Perform Step (4) for 4-in-1 bucket positions only.
(4)
Route cable (2) through eye loop (3).
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry contacts battery terminal, a direct
short may result in instant heating of tools, damage to equipment, and injury or death to personnel.
(5)
Connect light plug (1).
5-11
Change 1