|
| |
Back
Table 2-2.—Color Coding of Copper Terminal Lug or Splice Insulation | Up
Neets Module 04-Introduction to Electrical Conductors, Wiring Techniques, and Schematic Reading | Next
PREINSULATED SPLICES |
2-20
Figure 2-20.—Hand-crimping tools.
1. Strip the wire insulation using the recommended stripping procedures already discussed.
2. Ensure that the tool handles are fully open and the proper die set has been installed correctly.
3. Insert the terminal lug, tongue first, into the wire side of the hand tool barrel crimping jaws. Be
certain the terminal lug barrel butts flush against the tool stop on the locator. See figure 2-21 for
the correct insertion method.
Figure 2-21.—Crimping tool with terminal lug inserted.
|
