National Item Identification Number
01-124-5117
National Stock Number
Item Name
WASHER,FLAT
Federal Supply Class
5310
Description
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.
Commercial and Government Entity Code (Supplier Data)
10855
CARRIER CORPORATION
DIV CARRIER TRANSICOLD DIVISION
CARRIER PARKWAY BUILDING TR-20
SYRACUSE
NY
13221
315-432-6441
81860
D9182
13636
BARRY WRIGHT CORPORATION
DBA BARRY CONTROLS AEROSPACE
4510 VANOWEN STREET
BURBANK
CA
91505
818-843-1000
81860
81860
81860
Reference Numbers (Part Numbers)
PL CM/10-94 IT39
SB2000SERIES PG66
9810145-0-5804
9810145-05
9810145-05
981
Required Categories
MATERIAL
SURFACE TREATMENT
SURFACE TREATMENT DOCUMENT AND CLASSIFICATION
HOLE
Required Description
STEEL OVERALL
ZINC OVERALL
BARRY 804,FSCM 81860 MFR REF SINGLE TREATMENT RESPO