|
| |
Back
27-3. BODY WIRING HARNESS REPLACEMENT (Cont’d) | Up
TM-9-2320-387-24-2 Truck Utility: Shelter Carrier 4 x 4 M113 Truck Utility: UP-Armored Carrier 4 x 4 M114 Manual | Next
27-3. BODY WIRING HARNESS REPLACEMENT (Cont’d) |
TM 9-2320-387-24-2
1 10-9. HOOD AND HINGE MAINTENANCE (Cont’d)
I
pLTizGq
NOTE
Perform steps 1 and 2 if hinges were removed.
1.
Install two lower hinge halves (8) on headlight housing (5) with four washers (41, capscrews (2),
washers (7), and locknuts (6). Do not tighten locknuts (6).
2.
Install two upper hinge halves (11) on hood brackets (14) with four washers (IO), capscrews (91,
washers (151, and locknuts (16). Tighten locknuts (16) to 28 lb-ft (38 N-m).
3.
Install hood (17) and align two upper hinge halves (11) with lower hinge halves (8).
4.
Install two upper hinge halves (11) on lower hinge halves (8) with washers (131, hinge pins (12.1,
washers (31, and cotter pins (1).
5.
Install washer (20) and hood prop rod (21) on hood (17) with washer (19) and cotter pin (18).
6.
Connect left and right hood harness connectors (22) to harness connector (23).
lo-16
|
