REAR ANTENNA CABLES REPLACEMENT (Cont’d)

nut and lockwasher assembly (23). b. Installation TM 9-2320-280-20-3 12-140. REAR ANTENNA CABLES REPLACEMENT (Cont’d) 16. 17. 18. 19. 20. 21. 22. NOTE Perform steps 16 through 22 for M998, M998A1, M1038, and M1038A1 models only. Remove nut and lockwasher assembly (23), capscrew (25), clamp (26), two antenna cables (1), and body harness (24) from body (22). Discard nut and lockwasher assembly (23). Remove two capscrews (28) and lockwashers (27) from cable shield (21) and body (22). Pull cable shield (21) away from body (22) to allow access to clamps (30). Discard lockwashers (27). Remove two nut and lockwasher assemblies (29), capscrews (20), clamps (30), antenna cables (1), and body harness (24) from cable shield (21). Discard nut and lockwasher assemblies (29). NOTE Note position of clamp for installation. Remove nut (18), clamp (31), and two antenna cables (1) from antenna mounting bracket cap screw (19). Discard nut (18). Disconnect two antenna cables (1) from antenna base (14), and push grommet (33) and antenna cables (1) through grommet opening (32) in body (22). Remove grommet (33) from antenna cables (1). Remove antenna cables (1). Remove clamps from two antenna cables (1) and body harness (24) as required. 1. Install two antenna cables (1) in approximate mounting location. 2. Inatall clamps and grommet (33) on two antenna cables (1) and body harness (24) as required. NOTE Perform steps 3 through 8 for M998, M998A1, M1038, and M1038A1 models only. 3. Insert antenna cables (1) through grommet opening (32) and install grommet (33) in body (22). 4. Connect antenna cables (1) to antenna base (14). 5. Install two antenna cables (1) on antenna mounting bracket capscrew (19) with clamp (31) and nut (18). 6. Install two antenna cables (1) and body harness (24) on shield (21) with two clamps (30), cap- screws (20), and nut and lockwasher assemblies (29). 7. Install shield (21) on body (22) with two lockwashers (27) and capscrews (28). 8. Secure two antenna cables (1) and body harness (24) to body (22) with clamp (26), capscrew (25), and 12-217