|
| |
Back
RIGHT FRONT COWL INSULATION REPLACEMENT | Up
TM-9-2320-280-20-3 Truck Utility Cargo/Troop 1-1/4 Ton 4x4 Manual | Next
TUNNEL INTERIOR SIDE INSULATION REPLACEMENT FIG. |
TM 9-2320-280-20-3
10-28. TUNNEL INTERIOR SIDE INSULATION REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Equipment Condition
General mechanic’s tool kit:
s Left front cowl insulation removed (para. 10-26).
automotive (Appendix B, Item 1)
l Front floorboard removed (para. 11-154).
Manual References
TM 9-2320-280-24P
NOTE
Removal and installation procedures for all tunnel interior side
insulation are basically the same. This procedure covers the left
front insulation.
1. Remove two screws (4) from retaining rod (5) and cargo floor (6).
2. Remove two screws (2) from retaining rod (3) and cargo floor (6).
3. Remove three screws (1) and retaining rod (8) from tunnel (7) and cargo floor (6).
4. Remove two screws (9) from retaining rod (10) and tunnel (7).
5. Remove two screws (14), retainer (12), and insulation (11) from floor (13).
6. Remove retaining rods (3), (5), and (10) from insulation (11).
b. Installation
1. Install retaining rods (10), (3), and (5) on insulation (11).
2. Position insulation (11) into place against floor (13), tunnel (7), and cargo floor (6).
3. Install insulation (11) and retainer (12) on floor (13) with two screws (14).
4. Install retaining rod (10) on tunnel (7) with two screws (9).
5. Install retaining rod (8) on tunnel (7) with three screws (1).
6. Install retaining rod (3) on cargo floor (6) with two screws (2).
7. Install retaining rod (5) on cargo floor (6) with two screws (4).
10-48
|
