|
| |
Back
ENGINE RIGHT SPLASH SHIELD MAINTENANCE FIG. | Up
TM-9-2320-280-20-3 Truck Utility Cargo/Troop 1-1/4 Ton 4x4 Manual | Next
ENGINE RIGHT SPLASH SHIELD MAINTENANCE FIG. |
TM 9-2320-280-20-3
10-20. ENGINE RIGHT SPLASH SHIELD MAINTENANCE (Cont'd)
NOTE
Perform step 2 only if vehicle has an armor plate.
2. Remove locknut (2), washer (3), capscrew (4), washer (3), and armor plate (1) from splash shield (5).
Discard locknut (2).
3. Remove seven locknuts (10), washers (9), capscrews (7), seal retainers (6), and seal (8) from splash
shield (5). Discard locknuts (10).
1. Install seal (8) and seal retainers (6) on splash shield (5) with seven capscrews (7), washers (9), and
locknuts (10).
NOTE
Perform step 2 only if vehicle has an armor plate.
2. Install armor plate (1) on splash shield (5), ensuring capscrew holes align, and secure with washer (3),
capscrew (4), washer (3), and locknut (2). Tighten locknut (2) to 15 lb-ft (20 Nom).
3. Install support plate (15) on splash shield (5), ensuring capscrew holes align, and secure with
washer (14), capscrew (13), washer (14), and locknut (16).
d. Installation
1. Install splash shield (5) on airlift bracket (12) with two washers (31) (vehicles without armor plate),
lockwashers (26), and screws (25).
2. Install fuel line clamp (24) on splash shield (5) with capscrew (11), washer (22), and lochnut (23).
3. Secure splash shield (5) to airlift bracket (12) with lockwasher (20), washer (18), capscrew (21),
washer (19), washer (18), and locknut (17). Tighten capscrew (21) to 10 lb-ft (14 Nom).
4. Secure splash shield (5) to support bracket (27) with washer (28), capscrew (30), washer (28), and
locknut (29). Tighten capscrew (30) to 15 lb-ft (20 N.m).
10-36
|
