|
| |
Back
3.5-TON JACK STOWAGE BRACKET AND COVER REPLACEMENT | Up
TM-9-2320-280-20-3 Truck Utility Cargo/Troop 1-1/4 Ton 4x4 Manual | Next
ENGINE RIGHT SPLASH SHIELD MAINTENANCE FIG. |
10-20. ENGINE RIGHT SPLASH SHIELD MAINTENANCE
This task covers:
a. Removal
c.
Assembly
b. Disassembly
d. Installation
a. Removal
1.
Remove locknut (7), washer (6), capscrew (8), and washer (6) from splash shield (1) and support
bracket (5). Discard locknut (7).
2.
Remove locknut (15), washer (16), washer (17), capscrew (19), lockwasher (18), and washer (16)
from splash shield (1) and airlift bracket (4). Discard locknut (15) and lockwasher (18).
3.
Remove locknut (21), washer (20), capscrew (10), and fuel line clamp (22) from splash shield (1).
Discard locknut (21).
4.
Remove two screws (2), lockwashers (3), washers (9) (vehicles without armor plate), and
splash shield (1) from airlift bracket (4). Discard lockwashers (3).
NOTE
Right splash shield maintenance is the same for all vehicles, except
M998, M998A1, M1035, M1035A1, M1035A2, M1037, M1038,
M1038A1, and M1042 vehicles do not have an armor plate attached
to side of shield.
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Twelve locknuts (Appendix G, Item 65)
Three lockwashers (Appendix G, Item 109)
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
• Hood raised and secured (TM 9-2320-280-10).
• 3.5-ton jack stowage bracket and cover removed
(M1123 and “A2” series only) (para. 10-19).
b. Disassembly
1.
Remove locknut (14), washer (12), capscrew (11), washer (12), and support plate (13) from splash
shield (1). Discard locknut (14).
TM 9-2320-280-20-3
10-34
Change 1
|
