INSTALLATION

TM 10-5411-231-13&P CARGO BED COVER (CBC) HMMWV, TYPE I 0010 00 SERVICE UPON RECEIPT Detach the pallet from CBC by removing the six bolts, nuts and washers. Save hardware for later use in reshipment. Attach a lifting device capable of lifting at least 1 ton to each of four lift rings located near the top corners of the CBC, and remove from pallet. The CBC is ready to be installed. WARNING Safe loading of the CBC requires two personnel. Stay clear of the unit while lifting, as serious injury can result if unit swings or drops and hits personnel. INSTALLATION Attach CBC to a lifting device by hooking onto the four lift rings and set CBC onto a HMMWV. Open CBC upper and lower doors. Carefully align the six predrilled holes on floor of CBC with holes located on HMMWV bed. Remove the kit installation hardware (P/N 104244) supplied and located in a bag attached to the 24” ladder. Using this hardware, attach CBC to HMMWV as follows and refer to the CBC Installation illustration. 1. Insert three bolts (2) with three rubber gaskets (6) through the holes on top, located at the forward end of the CBC. From below, attach three flat washers (3) and three self-locking nuts (5). Attach plates (7), one on the left side and one on the right side of CBC underneath the HMMWV. Attach plate (8) with hole in center, in the center of CBC, and underneath the HMMWV. See illustration. Hand tighten. 2. Insert three screws (4) through the holes on top (through the door frame tabs), located at the aft end of the CBC. 3. From below, attach three flat washers (3) and three self-locking nuts (5). Hand tighten. 4. Securely tighten all six nuts (5) from below. Lift Ring END OF TASK 0010 00-2