Table 1-7. Equipment Used for NDI

TM 1-1520-265-23 Table 1-7. Equipment Used for NDI Fluorescent Penetrant Fluorescent Penetrant Inspection Kit Method Black Light UV Kit Black Light Meter Black Light Bulbs Filter UV Magnetic Particle Method Yoke and Coil Kit Black Light Magnetic Particle Inspection Probe Magnetometer Eddy Current Method Eddy Current Inspection Unit Cable Assembly, Coaxial 6-feet long (1 required) Reference Block Aluminum (0.008, 0.020, and 0.040 EDM notches) Reference Block Titanium (0.008, 0.020, and 0.040 EDM notches) Reference Block Magnesium (0.008, 0.020, and 0.040 EDM notches) Reference Block - Block of Six Conductivity Samples Probe, straight, shielded surface 100 KHz-500 KHz Probe, right angle, shielded surface 100 KHz-500 KHz, 90° 1/2 inch drop Ultrasonic Method Ultrasonic Inspection Unit Cable Assembly, BNC to microdot Transducer 5 MHz 45°S Shear 1/4 x 1/4 Bond Testing Method Bond Test Inspection Unit Cable Assembly Probe, Mechanical Impedance Analysis Probe Holder, spring loaded Test Block, Composite Defect Standard #1 Test Block, Composite Defect Standard #3 Test Block, Aluminum Honeycomb with 0.020 inch thick aluminum /honeycomb skin (refer to Appendix C) Test Block, Aluminum Honeycomb with 0.040 inch thick aluminum skin (refer to Appendix C) Test Block, Aluminum Honeycomb with 0.063 inch thick aluminum skin (refer to Appendix C) Radiographic Method Tripod X-Ray Tubehead Stand Signal Appliance Lamp Assembly X-Ray Unit (LPX-160 Water Cooled Digital) Film Processor NOTE: Refer to Appendix B for equipment part number, national stock number, and manufacturer. 1-38