|
| |
Back
Table 1-4. Penetrant Procedure (Type I, Method B) | Up
TM-1-1520-265-23 H-60 Helicopter Series Manual | Next
Table 1-6. Penetrant Procedure (Type I, Method D) |
TM 1-1520-265-23
Table 1-5. Penetrant Procedure-Portable or Field Application
(Type I, Method C)
Task
Description
a. Preparation of Part:
Refer to Preparation of Part or Area for NDI, paragraph 1.4.4.
b. Precleaning Procedure:
Refer to TM 1-1500-344-23.
c. Penetrant Application:
Apply penetrant either by brushing or spraying. In a confined
area, apply with brush to prevent overspray.
d. Penetrant Dwell:
Allow a minimum of 30 minutes penetrant dwell time. In tem-
perature below 16°C (60°F), refer to Nondestructive In-
spection. Methods manual listed in Table 1-1 for dwell time
compensations.
e. Penetrant Removal:
Wipe dry with a dry, lint-free cloth. Wipe down with a solvent-
moistening cloth. Check area to be inspected with black
light to be sure all surface penetrant has been removed be-
fore applying developer. Do not spray cleaner directly onto
part.
f. Developer Application:
Spray a light film of developer over area to be inspected.
g. Inspect:
Perform inspection under black light. Observe any obvious
bleed-out as developer dries. Complete inspection after
developer dwell time is complete.
h. Materials:
Type I, Method C, Level 3 or 4, Solvent - Removable Fluores-
cent Dye Penetrant (Refer to Table 1-8).
1-24
|
