TM-9-2540001.gif
TM-9-2540002.gif
TM-9-2540003.gif
TM-9-2540004.gif
TM-9-2540005.gif

Tm-9-2540-207-14p

• Section 1 Introduction
• Principles Of Operation
• Heat Exchanger
• Ventilation Air
• Specifications
• Figure 1-2. Heater, General Dimensions
• Shipping Container
• Heater Operation Verification
• Storage
• Section 2 Installation
• Combustion Air Inlet Connection
• Electrical Connections
• Fuel Inlet Connection
• Heat Outlet Connection
• Section 3 Operating Instructions
• Normal Operation
• Shutdown Procedures
• Heater Data Codes Mode
• Warning & Shutdown Faults
• Section 4 Heater Maintenance
• Section 4 Heater Maintenance Cont.
• Periodic Service And Inspection
• Igniter & Igniter Holder Maintenance
• Igniter & Igniter Holder Maintenance (Continued)
• Section 5 Heater Repair
• Figure 5-1. Heater, Major Assemblies
• Figure 5-1.1. Shell Assembly
• Figure 5-1.2. Top Cover
• Figure 5-1.3. Top Shell
• Top Shell (Continued)
• Bottom Shell
• Bottom Shell (Continued)
• Vent Fan Assembly
• Vent Fan Assembly
• Vent Fan Assembly (Continued)
• Vent Fan Assembly (Continued)
• Motor Magnet
• Motor Magnet (Continued)
• Vent Fan Shroud
• Vent Fan Shroud (Continued)
• Vent Fan Impeller Assembly
• Vent Fan Impeller Assembly (Continued)
• Vent Fan Impeller Assembly (Continued)
• Electronic Programmed Controller & Vent Fan Driver Boards
• Electronic Programmed Controller & Vent Fan Driver Boards (Continued)
• Electronic Programmed Controller & Vent Fan Driver Boards (Continued)
• Electronic Programmed Controller & Vent Fan Driver Boards (Continued)
• Vent Fan Motor
• Vent Fan Motor (Continued)
• Combustion Assembly
• Combustor Assembly
• Combustor Assembly (Continued)
• Flame Tube
• Igniter
• Igniter Holder
• Igniter Holder (Continued)
• Burner Chamber
• Burner Chamber (Continued)
• Burner Chamber (Continued)
• Burner Cartridge
• Burner Cartridge (Continued)
• Burner Cartridge (Continued)
• Burner Housing
• Burner Housing (Continued)
• Burner Housing (Continued)
• Heat Exchanger Assembly
• Heat Exchanger
• Heat Exchanger (Continued)
• Heat Exchanger (Continued)
• Heat Exchanger (Continued)
• Vent Sensor Assembly
• Vent Sensor Assembly (Continued)
• Vent Outlet Seal
• Top Housing Assembly
• Top Housing Assembly Cont.
• Fuel Pressure Sensor
• Fuel Pressure Sensor (Continued)
• Diagnostic Display
• Fuel Pump
• Fuel Pump (Continued)
• Burner Fan Plate Assembly
• Burner Fan Plate Assembly (Continued)
• Burner Fan Plate Assembly (Continued)
• Burner Fan Plate Assembly (Continued)
• Fuel Injector
• Fuel Injector (Continued)
• Power & Logic Wiring Harnesses
• Power And Logic Wiring Harnesses (Continued)
• Power And Logic Wiring Harnesses (Continued)
• Power And Logic Wiring Harnesses (Continued)
• Section 6 Troubleshooting
• Warning & Shutdown Faults
• Troubleshooting Guidelines
• C1 - Igniter Failure
• C2 - Igniter Short
• C3 - Vent Fan Fault
• C4 - Burner Fan Fault
• C5 - Burner Sensor Fault
• C6 - Vent Sensor Fault
• C7 - Fuel Pressure Sensor Fault
• C8 - Controller Fault
• C9 - Fuel Pump Fault
• Ca - Fuel Injector Fault
• E1 - Low Voltage
• E2 - Low Fuel Pressure
• E3 - Low Burner Air Flow
• E4 - Reverse Burner Air Flow
• E5 - Inlet Over Pressure
• E6 - Over Voltage
• F1 - Ignition Overtime
• F2 - Burner Flame Out
• F3 - Heat Limit
• F4 - Vent Air Overheat
• F5 - Over Current
• F6 - Inlet Overheat
• F7 - Exhaust Overheat
• F8 - Ignition Flame Out
• Appendix A List Of References
• References-- Continued
• Appendix B Maintenance Allocation Chart
• Maintenance Functions
• Explanation Of Columns In The Mac
• Explanation Of Columns In Tool And Test Equipment Requirements
• Section Ii. Maintenance Allocation Chart
• Section Ii. Maintenance Allocation Chart - Continued
• Section Ii. Maintenance Allocation Chart - Continued
• Section Ii. Maintenance Allocation Chart - Continued
• Appendix C Expendable Supplies And Materials List
• Section Ii. Expendable Supplies And Materials List
• Appendix D Unit, Direct Support General Support Maintenance Repair Parts And Special Tools Lists
• Explanation Of Columns In The Repair Parts List And Special Tools List Work Packages
• Source Code
• Fourth Position
• Recoverability Code
• Description Of Usable 'On Code' (Uoc)
• Special Information
• How To Locate Repair Parts
• Figure D-1. Igniter And Cover Assembly
• Description And Usable On Codes
• Figure D-2. Vent Housing Assembly
• Description And Usable On Codes Cont.
• Figure D-3. Burner Assembly
• Description And Usable On Codes Cont.
• Figure D-4. Heat Exchanger Assembly
• Description And Usable On Codes Cont.
• Figure D-5. Top Housing Assembly
• Description And Usable On Codes Cont.
• Figure D-6. Logic And Power Wiring Harnesses
• Description And Usable On Codes Cont.
• Figure D-7. Shell Assembly
• Description And Usable On Codes Cont.
• Description And Usable On Codes Cont.
• Cross Reference Indexes
• Cross Reference Indexes Cont.
• Appendix E Control Flow Charts
• Figure E-2. Run Control Flow Chart
• Figure E-3. Purge Control Flow Chart
• Figure F-1. Heater Name Plate Label
• Figure F-2. Diagnostic Code Label
• Conversion Tables

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing