REMOVE COMBUSTOR CASE (AVIM) (CONT)

TM 55-2835-209-23 3-1 REMOVE COMBUSTOR CASE (AVIM) (CONT) Exercise care when disconnect- ing igniter plug lead to pre- vent damage to igniter plug lead tips. To prevent clogging or contam- ination, all exposed openings in fuel, oil, air lines and electrical connectors will be capped or plugged immediately. Be sure caps and plugs are clean. 1. Disconnect igniter plug lead (1) from igniter plug assembly (2). 2. Remove igniter plug assembly (2) and washer (3) from combustor case. 3. Remove nut (4), bolt (6). 4. Remove nut (7) and NOTE (5) and clamps bracket (8). To aid in assembly, leads should be marked prior to re- moval. 5. Remove nuts (9, 10). nut (11, de- leted) from immersion thermocouple (16). Remove leads (12) from stud marked (AL) and stud marked (CR). Install nuts (9, 10) back on immer- sion thermocouple. 6. Remove nuts (13), bolts (14), stud (15, deleted) and ground wire. 7. Remove immersion thermocouple (16). 8. Remove gasket (17) from immersion thermocouple and discard. 3-2 Change 1