|
| |
Back
REMOVE AIR SCREEN ASSEMBLY (Continued) | Up
TM-55-2835-208-23 Transportability Guidance Small Emplacement Excavator (SEE) High Mobility Entrencher (HME) High Mobility Material Handler (HMMH) Manual | Next
CLEAN AND INSPECT AIR SCREEN ASSEMBLY (Continued) |
TM 55-2835-208-23
2-2 CLEAN AND INSPECT AIR SCREEN ASSEMBLY
2-2
INITIAL SETUP
Materials:
Applicable Configurations:
Methyl-Ethyl-Ketone (MEK) (E9)
Stiff Fiber Brush (E10)
All
Personnel Required:
Tools:
68B Aircraft Powerplant Repairer
Rubber Gloves
68B Powerplant Inspector
NSN 8415-00-266-8677
Container
Equipment Condition:
Eye Protection
Off APU Task
MEK is flammable and
toxic.
It can irritate
skin and cause burns.
Use only in well-ventilated
area, away from heat and
open flame. Wear gloves
and eye protection. In
case of contact, immediately
flush skin or eyes with
water for at least 15
minutes.
Get medical
attention for eyes.
Note
Use a stiff fiber brush
(E10) to remove deposits.
1. Wearing gloves and eye pro-
tection, degrease air screen
assembly(2) using MEK (E9).
2. Inspect for loose, missing, or
cracked
lacing
hooks
(l).
There
shall be no
loose,
cracked or
missing
lacing
hooks (1).
If loose, repair
(Task 2-3).
If missing or
cracked,
replace
air
screen
assembly (2).
GO TO NEXT PAGE
2-4
|
