|
| |
Back
Turnlock Fasteners Replacement. (cont) | Up
TM-5-6115-612-34 Gas Turbine Engine Driven Aviation Generator Set Manual | Next
Figure 2-2. Generator Replacement (Sheet 1 of 2) |
ARMY
TM 5-6115-612-34
MARINE CORPS TM 6115-34/8
AIR FORCE
TO 35C2-3-471-2
NAVY
AG-320BO-MME-OOO
Section IV.
REMOVAL AND INSTALLATION OF MAJOR COMPONENTS
2-5. GENERAL.
This section contains
instructions for removal and instal-
(10) Remove nuts (8), lockwashers
(9), and capscrews (10) that secure oil
lation of the generator, engine and
filler/breather support bracket (11).
gearbox, and the control panel.
WARNING
2-6. GENERATOR REMOVAL AND INSTAL-
LATION.
The
generator weighs
approxi-
mately 56 pounds (25.4 kg). To
a.
Removal
prevent injury, use proper lift-
ing device during removal and
(1) Set handbrake and chock both
installation.
wheels.
(11) Rig sling and lifting device
to support generator.
WARNING
(12) Use starter/manifold wrench
and
loosen nuts
(12) that secure
To prevent injury, ensure that
generator on gearbox.
It is not
battery
is disconnected before
necessary to remove nuts, lockwashers
performing maintenance on elec-
(13), and washers (14).
trical components.
(13) Rotate generator (15) clock-
(2) Disconnect battery cable plug
wise on mounting studs (16).
connector from battery.
(14) Ensure that lifting device
(3) Loosen turnlock fasteners and
is supporting weight of generator.
remove engine housing access cover.
(15) Pull generator forward and
(4) Tag and disconnect electrical away from gearbox (17).
connections from positive (+) and neg-
ative (-) stud connectors (1 and 2,
(16) Lift generator from engine
figure 2-2) on filter box (3).
housing and take to clean work area.
(5) Tag and disconnect electrical
b. Installation.
connector from GECM connector (4).
WARNING
(6) Disconnect
oil
filler/
breather vent tube (18) and oil return
The
generator
weighs
approx-
line (19) from breather assembly.
imately 56 pounds (25.4 kg). TO
prevent injury, use proper lift-
(7) Unscrew and remove filler cap
ing device
during removal and
and oil level gage (5).
installation.
(8) Tag and disconnect electrical
(1) Rig sling and lifting de-
connector from speed sensor (20).
vice.
Lift generator
(15)
into
(9) Loosen hose clamp (6) at top
position in engine housing.
of oil filler tube (7) and install
(2) Push generator into place on
protective cap.
gearbox mounting studs (16).
2-57
|
