ARMY TM  5-6115-612-12 MARINE  CORPS  TM  6115-12/7 AIR  FORCE TO 35C2-3-471-1 NAVY AG-320B0-0MM-000 4-3. MOVING THE GENERATOR SET. (cont) c. Movement by Hoisting Device or Helicopter. (cont) WARNING The generator set weighs approx- imately 1175 pounds (533 kg). To prevent  injury, ensure that all cables. shackles. and the hoist- ing device are capable of generator set. CAUTION To prevent damage, do not to  lift  the  generator tiedown rings are damaged. lifting attempt set  if (1) Inspect tiedown rings. (2) Attach appropriate cables and shackles to   tiedown rings (figure 4-5). Lift  point  shall  be  centered above the generator set. (3) Attach cables and shackles to hoisting  device. Using hoisting de- vice, slOWlY take a strain on cables. If  necessary,  place cables and generator prevent damage. padding  between set  housing  to W A R N I N G To  prevent  injury,  ensure  that all personnel stand clear while generator set is suspended from hoisting  device. (4) Slowly lift generator set and move to new worksite. 4-10 d. Movement by Forklift. The gen- erator set can be moved short distances with a forklift. The generator set must be lifted from the rear using the forklift tubes (figure 4-6). e. Manual  Movement. The  generator set   can   be   manually   moved by   two persons. One person is stationed at the rear of the generator set to push and the other person is stationed at the front to guide/steer the generator set. 4-4. After using a. REINSTALLATION AFTER  MOVEMENT. moving, install the generator set the  following  procedures. Movement by Vehicle. (1)  Pull  release  pin  and  lower swivel caster to down position. Ensure that release pin is securely engaged. WARNING To prevent injury, do not attempt to lift the front of the generator set with less than two persons. (2) Open pintle  and disengage from  lunette  eye. Lower front of gen- erator set to ground. WARNING To  prevent  injury,  ensure  that handbrake  is  set  whenever  the generator set is parked. (3) Set handbrake (figure 4-4).