Section II. MOVEMENT TO A NEW WORKSITE

A R MY TM 5-6115-612-12 MARINE CORPS TM 6115-12/7 AIR FORCE T0 35C2-3-471-1 N A V Y AG-320B0-0MM-000 Section II. MOVEMENT TO A NEW WORKSITE 4-3. MOVING THE GENERATOR SET. The (2) Open pintle. generator set can be moved by forklift, towed by vehicle, moved with a hoisting device or helicopter, or manually moved WARNING by two persons. Steps to prepare the generator set for movement are the same To prevent injury, do not attempt for each method. to lift the front of the a. Preparation for Movement. generator set with less than two persons. (1) Ensure that MASTER SWITCH is OFF and control panel access door is secured. (3) Raise front of generator set (2) Ensure that all access covers and lock lunette eye into pintle. and doors are secure. (3) Ensure that power cable is (4) Pull release pin and swing swivel caster into stowed position properly stowed and that ground wire is disconnected. until release pin engages hole. b. Movement by Vehicle. c. Movement by Hoisting Device or (1) Release handbrake (figure Helicopter. Refer to FM 55-450-1 for 4-4) and guide generator set toward additional information on performing pintle of tow vehicle. helicopter external load missions. Figure 4-4. Setting the Handbrake 4-9