INSTALLATION

ARMY TM 5-6115-612-12 NAVY AG-320B0-0MM-000 4-1. INSPECTING AND EQUIPMENT. (cont) d. Servicing the SERVICING THE Generator Set. (cont) NOTE Correct the hydrometer reading to 80°F (27°C) by adding 0.004 for each 10°F that ambient temperature exceeds 80°F (27°C), or by subtracting 0.004 for each 10°F that ambient temperature is below 80°F (27°C). (g) if, after correction, the specific gravity of any cell measures below 1.270, the battery should be charged (Para 4.27.b (2)). If any cell cannot be charged to a specific gravity of at least 1.270, the battery is not acceptable and should be replaced. (h) lnstall filler caps and battery cover. Install battery hold-down and tighten. (i) Connect battery cable plug connector to battery. (4) Open control panel access door and check all press-to-test fault indicators. (5) Test operate generator set in accordance with the following procedure. (a) Start engine (paragraph 2-3) and run for five minutes. Shut engine down (paragraph 2-5). (b) Loosen turnlock fasteners and remove engine housing access cover. Inspect oil filter, oil lines and fittings, and fuel lines and fittings in the engine compartment for leaks. Tighten all lines and fittings as needed. (c) Remove oil filler cap and check oil level on dipstick. If necessary, add oil in accordance with lubrication order (figure 3-2). (d) Install oil filler cap hand tight. (e) Unlatch and open fuel housing access door. Secure in open position. (f) Inspect fuel lines, fittings, connections, and components for leaks. Tighten fittings and con- nections as needed. (g) Close and securely latch fuel housing access door. (h) Stow power cable on cable support assembly. (i) Install engine housing access cover and secure with turnlock fasteners. (j) Check tires for proper inflation (30 psi- 206.84kPa). 4-2. INSTALLATION. a. General. Installation procedures include positioning the generator set on a level surface in a well-ventilated area and setting the handbrake. Select a site that allows for the clearances shown in figure 4-2, plus working room. Additionally, the generator set should be within easy access of an approved grounding facility. Approved grounding facilities can be attained using either of the procedures described in the following paragraph. See figure 4-3. 4-4 Change 2