|
| |
Back
Table 3-1. Consumable Operating and Maintenance Supplies - Continued | Up
TM-5-6115-612-12 Generator Set Diesel Engine Driven Tactical Skid Mtd. 600 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual | Next
Figure 3-2. Lubrication Order (Sheet 1 of 2) |
ARMY
TM 5-6115-612-12
MARINE CORPS TM 6115-12/7
AIR FORCE
T0 35C2-3-471-1
NAVY
AG-320B0-0MM-000
Section II.
LUBRICATION INSTRUCTIONS
3-2. GENERAL.
This section contains
b. Checking
and Adding
Lubrication
a reproduction of the lubrication order
oil.
and lubrication instructions that are
supplemental to,
and not specifically
(1) Unscrew and remove oil filler
covered in, the lubrication order. The
cap (figure 3-1).
lubrication order is an exact repro-
duction
of the approved
lubrication
(2) Wipe oil level gage clean.
order.
Refer to Army LO 5-6115-612-12.
(3) Reinsert oil level gage and
tighten oil filler cap finger tight.
(4) Unscrew and remove oil filler
cap.
Lubricant
and
Equipment
Storage.
Keep all lubricants in closed
containers and store in a clean, dry
place away from external heat.
Allow
no
dust,
dirt, or
other
foreign
material to mix with the lubricants.
Keep all lubrication equipment clean
and ready to use.
a.
(5) Check oil level on oil level
gage.
Add lubricating oil as neces-
sary to obtain
FULL reading on oil
level gage.
Refer to lubrication order
(figure 3-2) for proper lubricating oil.
(6) Reinsert oil level gage and
hand tighten oil filler cap.
Figure 3-1.
Checking Lubricating Oil
3-3
|
