Overall dimensions and weights (cont)

TM 5-6115-590-12 Heat exchanger heating.................... inflation ejector .......................................... 200 scfm (min) capacity.............................................60,000 btu/hr at (9) Vacuum system sea level and Vacuum source......................................... Compressed air ambient through eductor temperature Suction by eductor....................................10 scfm at 18 to -65°F (-54°C) 20 in. Hg A Hot water storage tank (10) Engine fuel and bleed-air systems schematic. capacity.............................................15 gal (approx) Refer to figure 1-4. Hot water temperature.......................140° to 160 F (11) Engine electrical system schematic. (60° to 72° C) Refer to figure 1-5. Temperature-pressure (12) Engine lubrication system schematic. relief valve setting..............................200 °F (93° C), 75 Refer to figure 1-6. psig (13) Power plant electrical system schematic. High pressure relief Refer to FO-1 located in back of manual. valve setting ......................................100 psig (14) Cooled air system schematic. Hot water pressure switch Refer to figure 1-9. actuation: (15) Heated air system schematic. Close on use to.................................10 psig Refer to figure 1-10. Open on decrease at.........................5 psig (16) Water system schematic. Refer to figure 1-12. (8) Compressed air system (17) Instrument panel wiring diagram. Normal external Refer to figure FO-2 located in back of manual. discharge pressure...........................55 to 110 in. Hg (18) Engine and skid assembly wiring diagram. A Refer to figure FO-3 located in back of manual. Pressure through (19) Conditioned air system wiring diagram. Inflation ejector..................................1.5 psig (min) Refer to Figure FO-4 located in back of manual. Flow through Change 6 1-33(1-34 blank)