INSPECT T1 TEMPERATURE SENSOR (Cont)

TM 1-2840-252-23-2

2-55

REPAIR T1 TEMPERATURE SENSOR (Continued)

2-55

INITIAL SETUP

Materials

Crocus Cloth (E16)

Applicable Configurations:

Personnel Required:

All

Aircraft Powerplant Repairer

Aircraft Powerplant Inspector

Tools:

Equipment Condition

Dry, Compressed Air

Off Engine Task

Powerplant Mechanic's Tool Kit,

NSN 5180-00-323-4944

Technical Inspection Tool Kit,

NSN 5180-00-323-5114

NOTE

This repair is allowed, provided it does not cause

pins to break or crack.

Straighten bent pins (1)of T1 temperature sensor

(2) Use long-nose pliers to gently move pins (1) until

they are straight.

Remove corrosion from pins (1of T1 temperature

)

sensor (2) Polish pin, using in and out motion over

entire length of pin until corrosion is removed Use

crocus cloth (E16).

WARNING

When using compressed air for cleaning, use

approved protective equipment for eyes and face

Do not use more than30 psig air pressure Do not

direct air toward yourself or another person

Failure to comply could result in injury to eyes or

skin. In case of injury, get medical attention.

Wear goggles Remove loosened particles, using

clean, dry, compressed air

INSPECT

FOLLOW-ON MAINTENANCE

None

END OF TASK

2-363